SERVICE INSTRUCTIONS
14
ALWAYS IMMOBILISE THE ENGINE BEFORE UNDERTAKING ANY MAINTENANCE WORK ON
THE CHIPPER BY REMOVING THE KEY.
SAFE MAINTENANCE
HANDLE
blades with extreme caution to
avoid injury. Gloves should always be
worn when handling the cutter blades.
THE
drive belts should be connected
while changing blades, as this will restrict
sudden movement of the rotor.
THE
major components of this machine
are heavy. Lifting equipment must be
used for disassembly.
CLEAN
machines are safer and easier to
service.
AVOID
contact with fuel.
Product name: Copper Ease.
Copper Ease contains no hazardous ingredients at or above regulatory disclosure limits, however,
safety precautions should be taken when handling (use of oil-resistant gloves and saftey glasses are
recommended - respiratory protection is not required). Avoid direct contact with the substance and
store in a cool, well ventilated area avoiding sources of ignition, strong oxidising agents and strong
acids. Dispose of as normal industial waste (be aware of the possible existance of regional or national
regulations regarding disposal), do not discharge into drains or rivers.
In case of fire:
in combustion the product emits toxic fumes, extinguish with alcohol or polymer foam,
carbon dioxide or dry chemical powder. Wear self-contained breathing apparatus and protective clothing
to prevent contact with skin and eyes.
FIRST AID
Skin contact:
there may be mild irritation at the site of contact, wash immediately with plenty of soap
and water.
Eye contact:
there may be irritation and redness, bathe the eye with running water for 15 minutes.
Ingestion:
there may be irritation of the throat, do not induce vomiting, wash out mouth with water.
A safety data sheet for this product can be obtained by writing to the manufacturer at the
following address: Comma Oil and Chemicals Ltd., Deering Way, Gravesend, Kent DA12 2QX.
Tel: 01474 564311, Fax: 01474 333000.
COPPER EASE SAFETY INFORMATION
The Timberwolf TW 18/100G is subject to large vibrations during the normal course of operation.
Consequently there is always a possibility that nuts and bolts will work themselves loose. It is
important that periodic checks are made to ensure the security of all fasteners. Fasteners should be
tightened using a torque wrench to the required torque (see below).
Uncalibrated torque wrenches
can be inaccurate by as much as 25%. It is therefore essential that a calibrated torque wrench
is used to achieve the tightening torques listed below.
CHECK FITTINGS
Size
Pitch
Head
Torque Ib/ft
Torque Nm
Blade Bolts
M8
Standard
T40 Torq
22
29
Funnel Retaining Nuts
M12
Standard
19 mm Hex
60
80
General
M8
Standard
13 mm Hex
17
23
General
M10
Standard
17 mm Hex
34
46
General
M12
Standard
19 mm Hex
60
80
SAFE LIFTING OF THE CHIPPER
The lifting eye is designed to lift the machine’s weight only. Do not use
hoist hook directly on the lifting eye, use a correctly rated safety shackle.
Inspect the lifting eye prior to each use - DO NOT USE IF DAMAGED.
Summary of Contents for TW 18/100G
Page 18: ...CERTIFICATE OF CONFORMITY 17...