Timberwolf TW 18/100G, Operating Instructions Manual, Page: 10 / 30

OPERATING INSTRUCTIONS
9
ENGINE CONTROLS
The engine speed is controlled by the vertically adjustable lever shown in diagram below. With the
throttle lever in the
FAST position the machine is ready to chip. It MUST be pushed up as far as
possible to achieve a suitable working speed.
If no wood is to be chipped for a few minutes the throttle should be returned to the idle position.
DELIVERY
All Timberwolf 18/100G machines have a full pre - delivery inspection before leaving the
factory and are ready to use. Read and understand this instruction manual before attempting
to operate the Chipper. In particular, read pages 5-7 which contain important health and safety
information and advice.
OPERATOR’S PERSONAL PROTECTIVE EQUIPMENT REQUIRED
CHAINSAW safety helmet fitted with visor and
recommended ear defenders to an appropriate
specification.
HEAVY-DUTY work gloves with elasticated wrist.
CLOSE - FITTING heavy-duty non-snag clothing.
SAFETY footwear.
FACE MASK (if appropriate).
See page 5 for more detailed information.
Open fuel shutoff valve.
Pull choke handle out to “choke”
position.
Move throttle lever to “fast”. Always
operate engine with throttle in “fast”.
Push “on/off” rocker switch to “on”
position.
Grasp recoil rope handle. Pull
slowly until resistance is felt, then
pull rapidly to start engine and avoid
kickback.
Allow engine to warm up. In warm
weather temperatures or recently
operated conditions, move choke
handle slowly in towards the run
position. In cold weather, allow
engine to run smoothly before each
change. Operate with choke in “Run”.
STARTING THE ENGINE
THROTTLE
LEVER
CHOKE
FUEL
SHUTOFF
VALVE
ON / OFF
SWITCH
RECOIL
HANDLE