Timberk T-HG2-Q11T, Instruction Manual

Page: 16 / 20

IM2022
16
2. To connect to the electrical network, the device is supplied with a three-wire power cord (please note that
the power plug is not included in the delivery set).
3. To connect the device to the electrical network, connect the power cord to the fixed electrical network, and
then turn on the power to the device. If the length of the power cord is not long enough, you can use a power
outlet and plug (not included in the delivery set), designed for the power of the device, to connect to the
electrical network. The scheme is presented in the section "Wiring diagram".
ATTENTION!
1. The electric wire supplied to the socket from the power board must have a core cross section of at least
2.5 mm
2
(for copper wire).
2. A circuit breaker with a rated current of 25A must be installed in the power board to protect the electrical
wiring from overloads.
8. OPERATION OF THE DEVICE
Control panel
Fig 4*
*The appearance of the control panel may differ from the images in the manual
1. Operating mode selection knob
Used to select the following operating modes: ventilation mode , low heating power , high heating
power
2. Thermostat knob
Used to set the room heating temperature
Operation of the fan heater
1. Turning on
Make sure that the operating mode selection knob is set to position, then connect the device to the
power source and set the operating mode selection knob to position, the electric motor of the device will
turn on and the device will start operating in ventilation mode.
ATTENTION!
1. When the fan heater is turned on for the first time, a smell and smoke may appear (oil is burned from the
surface of the heating elements). Therefore, it is recommended that before installation, turn on the device in
heating mode for 10-20 minutes in a well-ventilated area.
2. After transporting or storing the fan heater at negative temperatures, keep it in the room where it is
supposed to be used, without plugging it into the mains for at least 2 hours. After a long period of storage or
a break in operation, do not turn on the device for the first time in the high heating power mode.