Timberk SWH RE11 100 V Instruction Manual Download Page 3

Page: 3 / 40

www.timberk.com • electrical storage water heater

1. Completely automatic control: automatic water heating, continuous auto-

matic water temperature control.
2.

DROP Defense

– leakage protection and protection against surplus pres-

sure within a tank (pressure safety valve).

HOT Defense

– two-stage overheating protection (thermostat and tempera-

ture limiter).
ALL PROTECTION SYSTEMS ARE RELIABLE AND SAFE.
3. Steel internal tank with a special titanium fine glass enamel coating,

applied by the modern electrostatic dry enameling method, is resistant to

corrosion and scale. Also enamel has an increased adhesive capability and

high ductility (hardened at 850°C), which allows it to expand and contract at

temperature drops in the same ratio as the internal tank walls not generating

microcracks, where corrosion may emerge.
4. Pipes of heating elements are designed taking into account high heat load:

safe and reliable, with an increased service life.

Certain precautions are to be observed upon use of the water heater. Im-

proper use due to ignoring precautions may harm health of the user and

other people as well as damage their property.
1. Any electrical appliance must be under control upon its use, especially if

there are children nearby. Make sure children do not touch the appliance.
2. Prior to installation of the water heater, not connecting it to the electri-

cal main, check and make sure that the outlet for the water heater has a

ground contact and it is properly earthed. If there is no earth loop in your

electrical main then using of the water heater will be dangerous for your life.
3. Connect the water heater only to 220V / 50Hz electrical main. If neces-

sary, find out parameters of your main at power suppliers.
4. To prevent overheating and risk of fire as well as damage of inner elec-

trical main do not modify the power cord’s length and do not connect the

water heater through power extension cord.
5. It is forbidden to switch on the water heater if it is not filled with water or

if water cannot go through the pressure safety valve.
6. Never use the water heater if it is damaged.
7. Do not remove the water heater cover when it is in operation.
8. Immediately unplug the water heater from the electrical main if strange

sounds, odour or smoke comes out from it.
9.Always unplug the water heater from the electrical main during thunder-

storm.
10. Prior to cleaning and maintenance of the water heater unplug it from

the electrical main every time. Cleaning and maintenance must be per-

formed in compliance with the instructions contained in this manual.
11. Do not use hazardous chemical substances to clean the water heater

and prevent their contact with the appliance.
12. To prevent electrical shock the damaged power cord must be replaced

only by qualified specialists in manufacturer’s authorized service centres.
13. To prevent electrical shock do not place the power cord nearby heating

devices and flammable or combustible agents.
14. As temperature of water in the water heater can reach 75°C when it is

in operation you should not place your body parts under hot water upon

the first run. To prevent burns you should adjust the temperature of the

outflowing water.
15. Do not use the water heater for purposes not stipulated in this instruc-

2. PRECAUTIONS

tion manual.
16. Do not use the water heater in an explosive or corrosive environment.

Do not store petrol and any other volatile flammable liquids near to the

appliance. It is very dangerous!
17. It is forbidden to make alterations in the design of the water heater or

modify it.
18. Any service works must be performed by a specialized organisation

and qualified specialists. Improper installation may cause voiding of guar-

antee maintenance.
19. The water heater is not intended for use by children and persons with

reduced physical, sensory or mental capabilities, or a lack of experience