F 2 function
12
Programme delay/acceleration
1. The power control unit is switched on
(left LED lights up in red/yellow or green depending on the mode)
2. Place the
fl
ip switch in the central position
3. Press the function key F 1 and keep it pressed down
4. Turn the control knob until the desired number of points lights up
orange in the illumination ring
5. Release the function key F 1 again
6. Programming complete
the desired delay/acceleration is now set
Note: The values 1 to 10 also cause a different delay and acceleration in the case of
the different locomotive types. This behaviour is also dependent on the set speed. The
value 1 means a short delay/acceleration, the value 10 means the maximum possible.
Manual operation of the start/stop function
The manual start/stop function can be used by pressing the F 2 function key:
A. In the delivery state.
B. he device was reset to the factory settings (refer to page 9).
1. Set the desired drive direction and speed.
2. Brie
fl
y press the start/stop button (F 2 right button)
3. Now the power control unit independently reduces the speed until the locomotive
comes to a standstill.
4. If the start/stop key is brie
fl
y pressed when the train is standing the locomotive
slowly starts moving and accelerates until the set speed is reached.
The right yellow LED lights up respectively when the start/stop function is active.
Value 1
Value 1
Value 2
Value 3
Value 4
Value 5
Value 6
Value 7
Value 8
Value 9
Value 10
no point orange (power control unit value approx. 0 – 5)
1 point orange (power control unit value approx. 10 – 15)
2 points orange (power control unit value approx. 20 – 25)
3 points orange (power control unit value approx. 30 – 35)
4 points orange (power control unit value approx. 40 – 50)
5 points orange (power control unit value approx. 50 – 60)
6 points orange (power control unit value approx. 60 – 70)
7 points orange (power control unit value approx. 75 – 85)
8 points orange (power control unit value approx. 85 – 95)
9 points orange (power control unit value approx. 95 – 105)
10 points orange (power control unit value approx. 05 – 120)
