tiki TC100ZW, Instructions For Use Manual

Page: 3 / 36

3
EN
WARNINGS
This device can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the device in a safe way and understand the hazards
involved.
Children should not play with the device.
Cleaning and user maintenance shall not be performed by children without supervision.
Always transport the heat pump in an upright position; exceptionally, it may be tilted by 35° in all
directions. Be careful not to damage the housing or the vital component parts of the heat pump during
transport.
The heat pump is not intended for industrial use and use in premises where corrosive and explosive
substances are present.
The connection of the heat pump to the mains should be performed in accordance with standards for
electrical appliances.
An all - poles disconnect switch should be installed between the heat pump and the mains in
accordance with the national installation standards.
The heat pump should not be in operation without water in the hot water tank, because of danger of
destruction of the compressor!
The installation should be performed in accordance with the valid regulations and the instructions of
the manufacturer. It should be performed by a professionally trained installation expert.
It is necessary to install a safety valve with the rated pressure (info on the data plate) to the inlet pipe
of the heat pump, to prevent the pressure in the water tank from rising by more than 0.1 MPa (1 bar).
Water may drip from the outlet opening of the safety valve, so the outlet opening should be set to
atmospheric pressure.
The outlet of the safety valve should be installed facing downwards and in a non - freezing area.
To ensure proper functioning of the safety valve, the user should perform regular controls to remove
limescale and make sure the safety valve is not blocked.
Do not install a stop valve between the heat pump and the safety valve, because it will impair the
functioning of the safety valve!
The elements in the electronic control unit are live even after pressing the off field (9) on the heat
pump.
If you disconnect the heat pump from the power supply, please drain any water from the pump to
prevent freezing.
Water is drained from the heat pump through the water tank inlet pipe. For this purpose it is
recommendable to install a special element or an outlet valve between the safety valve and the inlet
pipe.
Water can be drained from the pump through the boiler inlet pipe. For this purpose it is advisable to
install a special element or outlet valve between the inlet pipe and safety valve.
This product contains fluorinated greenhouse gases. Hermetically sealed.
Our products incorporate components that are both environmentally safe and harmless to health, so they can be
disassembled as easily as possible and recycled once they reach their final life stage.
Recycling of materials reduces the quantity of waste and the need for production of raw materials (e.g. metals) which requires
a substantial amount of energy and causes release of harmful substances. Recycling procedures reduce the consumption of
natural resources, as the waste parts made of plastic and metal can be returned to various production processes.
For more information on waste disposal, please visit your waste collection centre or the store where the product was purchased.
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!
!