tiki SHB10, Installation And User Manual

Page: 6 / 88

6 SHB10 TIKI
2 Delivery and handling
Transport
Available models
Compatibility
Assembly
The SHB10 unit can be used with Split type outdoor
units. The compatible SPLIT heat pumps are:
Outdoor unit Compatibility
AMS 10-6 SHB10-6
AMS 10-8
SHB10-12
AMS 10-12
AMS 10-16
SHB10-16
Section 2 | Delivery and handling
SHB10 units include the following separate models:
• SHB10-6 - unit dedicated for use with AMS 10-6.
• SHB10-12 - unit dedicated for use with AMS 10-8
and AMS 10-12.
• SHB10-16 - unit dedicated for use with AMS 10-16.
CAUTION
When the SHB 10 is stored or transported horizontally
with the display facing up, no devices / components
may be stored on top of the unit. It may damage the
device.
1. Place the included mounting hanger horizontally
against the wall. Level the hanger using the spirit
level. Mark the points for the mounting holes to
be drilled.
• SHB10 is equipped with wall-mounted hanger. For
mounting hole spacing, see drawing below.
• SHB10 must be hanged on walls of sufficient
load-bearing capacity able to take the weight of
a filled indoor unit.
• Since SHB10 is equipped with condensate drain-
off system, the indoor unit must be installed at
the site with sewage system drain.
CAUTION
The SHB10 unit must be hanged on the wall using
the included hanger. The device can be installed in
vertical position only.
130mm 130mm
2. Drill the holes in marked points.
3. Screw the attachments to the wall using the pro-
vided rawplugs and bolts.
4. Install SHB10 on the mounted hanger.
5. Level the device using the bottom adjustment
screws.
CAUTION
Included rawplugs should be assessed in terms of
load-bearing capacity and material of the wall on which
the device is to be hanged. Replace with the other
rawplugs meeting the requirements, if necessary.
More information on SPLIT heat pumps available at
www.tiki.si and in dedicated installation and user
manuals.
See section "Accessories" for the list of accessories
to be used with SHB10.
The SHB 10 indoor unit should be transported and
stored vertically or horizontally on the rear wall with
the display facing up. Storage location must be dry.
SHB 10 can be transported into the building vertically
or carefully placed on the rear wall with the display
facing up.