TIGMON Lauben 15BB, User Manual

Page: 21 / 84

| 21
TROUBLESHOOTING
Problem Possible cause Solution
1
The robotic vacuum cleaner suddenly
stops cleaning The robotic vacuum cleaner
has been lifted from the
surface Place the robotic vacuum cleaner back on the floor
and restart it with the main switch
2
When the robotic vacuum cleaner is
switched on, the LED lights up blue Fall sensor error 1. Clean the fall sensor
2. If this does not work, contact your dealer to
repair the robotic vacuum cleaner
3
The robotic vacuum cleaner does not
change direction when encounters
an obstacle Bumper sensor error Check that the sensor is not covered by anything
4
During charging, the LED flashes red
and the robotic vacuum cleaner beeps Power switch is not turned
on Switch on the robotic vacuum cleaner with the
main switch
5
The LED flashes red Low battery Fully charge the battery
6
The blue and red LED flash alternately The side brush has become
stuck Place the robotic vacuum cleaner on a flat surface
and clean the side brush
7
The blue LED flashes once, then the
red LED flashes twice The robot bumper is not
flexible enough Loosen the screw on the bottom of the bumper by
half a turn
8
The blue LED flashes once, then the
red LED flashes three times The wheel is stuck Check the wheel and remove any foreign object
Note:
If any of the above solutions do not resolve the problem, please follow the steps below:
1) Reset the robotic vacuum cleaner by turning on the switch on the control panel.
2) If the reset is unsuccessful, contact your dealer to repair the robotic vacuum cleaner.
Published information Value and accuracy Unit
Model ID number - -
Input voltage - -
Input frequency 100–240 V
Output voltage 50/60 Hz
Output current 19 V
Output power 0.6 A
Average efficiency in active mode 11.4 W
Low-load efficiency (10 %) >80 %
No-load power consumption >72 %
Spotřeba energie ve stavu bez zátěže <0.1 W
DE
EN
CZ
SK
PL
HU
SL
HR