TIGMON Lauben 15BB, User Manual

Page: 19 / 84

| 19
2. Spiral cleaning
In this mode, the robotic vacuum cleaner will clean in a spiral. If in standby mode, press the ON / OFF button on the remote control or
the „ “ switch on the robotic vacuum cleaner to start spiral cleaning.
3. Spot cleaning
Press the SPOT button on the remote control to start spot cleaning.
Notes:
■
The spot cleaning mode is suitable for areas with persistent dirt.
■
If in standby mode, press SPOT. The robotic vacuum cleaner will clean for about 30 seconds and then stop.
■
If you press the SPOT button when the robotic vacuum cleaner is already cleaning, it will perform spot cleaning for approximately
30 seconds and then return to the original cleaning mode.
4. Cleaning along the walls
Turn on the robotic vacuum cleaner, then press the MODE button on the remote control and select the “cleaning along the walls”
mode. In this mode, the robotic vacuum cleaner will clean along obstacles using its side brushes.
5. Zigzag cleaning
The robotic vacuum cleaner will automatically switch to zigzag cleaning mode if it detects that it is in an open space or environment
with a small number of obstacles. Alternatively, you can press the MODE button on the remote control and select zigzag cleaning.
Notes:
■
After switching on the robotic vacuum cleaner, specific cleaning modes can be selected by pressing the MODE button on the
remote control. You can stop the robotic vacuum cleaner with the ON / OFF button.
■
Mode 1 for spot cleaning
Mode 2 for automatic cleaning
Mode 3 for cleaning along the wall
Mode 4 for zigzag cleaning
Water emissions from the water tank
Water will naturally flow out of the water tank as a result of gravity, so after cleaning, remove the water tank from the robotic vacuum
cleaner.
Installing the water tank and mop cloth
1 2 3
Water tank base
Water tank
Mop cloth
Rubber
stopper
1. Installing the mop cloth
Attach the mop cloth to the bottom of the water tank (see figure 1). Make sure the sides of the mop cloth are in the correct direction
and attach the mop cloth to the robotic vacuum cleaner using the adhesive side.
2. Fill the tank with water
Remove the rubber stopper from the water container, fill the container with water and then return the stopper to the correct position
to prevent water leakage.
3. Attach the water tank to the robotic vacuum cleaner
Rotate the robotic vacuum cleaner and attach the water container to the bottom. Make sure that the pins are firmly pressed into the
mounting holes.
Notes:
■
Do not perform water cleaning on carpets.
■
The mop cloth must be correctly positioned on the water container so that it does not get caught in the wheels of the robotic
vacuum cleaner.
Warning:
Do not perform water cleaning on an untreated wooden floor without direct supervision, or on a floor that should be
dry-cleaned.
DE
EN
CZ
SK
PL
HU
SL
HR