TIGIEFFE Airo X Series, Use And Maintenance Manual

Page: 53 / 124

Use and Maintenance Manual - X Series Page 53
7.3.3 Hydraulic circuit oil level check and change
At least once a month check the tank level through the special window (Figure
7-6) and make sure it always lies between the min.
and max. values. If necessary top up until max. level is reached. The oil check should be carried out when platform is completely
lowered.
Completely change the hydraulic oil at least every two years.
To empty the tank (figure
7-7):
 lower the platform completely
 stop the machine by pressing the emergency stop button on the ground control panel
 disconnect the tubes from the tank
 unscrew flange
A
unlocking the screws with a Phillips screwdriver

remove the tank from its seat after removing bar C

pour the tank content in a suitable container, through the filler cap.
Use only the types of oil and quantity indicated in the table below.
HYDRAULIC SYSTEM OIL
BRAND
TYPE
-20°C +79°C
TYPE
-30°C +48°C
REQUIRED QUANTITY
SYNTHETIC OILS
28 Litres
ESSO
Invarol EP46 30
LITRES
Invarol EP22
AGIP Arnica 46 Arnica 22
ELF Hydrelf DS46 Hydrelf DS22
SHELL Tellus SX46 Tellus SX22
BP Energol SHF46 Energol SHF22
TEXACO Rando NDZ46 Rando NDZ22
BIODEGRADABLE OILS - OPTIONAL
PANOLIN HLP SINTH E46 HLP SINTH E22
Do not dispose of used oil in the environment. Comply with the current local standards.
The lubricants, hydraulic oils, electrolytes and all detergent products should be handled with care and disposed of in safety
according to the current regulations. A prolonged contact with the skin may cause irritations and dermatosis; wash with water and
soap and rinse thoroughly. Contact with eyes, especially with electrolytes, is also dangerous; rinse with water thoroughly and call
the doctor.