Laser Location
Laser location tells TigerStop where the laser is physically mounted in
relation to the TigerStop. For TigerScan, this setting must be set to ‘Motor
End’.
To change Laser Location...
1. Press [B] or [C] to toggle the setting.
2. Press the [Done] soft key to save the parameter.
Laser Limit
Laser Limit is the maximum scan length that TigerStop will accept. For
TigerScan, set this to the maximum length of your TigerStop.
To change Laser Limit...
1. Enter the TigerStop password, followed by [=].
Note: The default password is set to the serial number of the TigerStop.
2. Enter the new Laser Limit value.
3. Press the [Done] soft key to save the parameter.
Laser Reference
Laser Reference sets the end of the laser reference zone. This zone
signals the end of a stock length when laser scanning. Measure from the
defecting laser to the end of the material bumper.
To change Laser Reference...
1. Enter the TigerStop password, followed by [=].
Note: The default password is set to the serial number of the TigerStop.
2. Enter the new Laser Reference value.
3. Press the [Done] soft key to save the parameter.
