Tiger SIDE ROTARY JD6110-30M/R T4F, Mounting And Operating Instructions

Page: 42 / 202

ASSEMBLY
Assembly Section 2-12
DRAFT BEAM INSTALLATION
Install ½” O-ring breather into butt port of inboard cylinder. Install fittings in the rod end of the
cylinder according to the diagram in the Common Parts section. These fittings should be
positioned to face the butt end of the cylinder.
Next turn the clevis onto the rod of the cylinder until it is tight against the shoulder and lock
into place with locking bolt on clevis.
The inboard cylinder can now be installed into the main frame mast with the pin, flatwasher
and R-clip as shown below.
Install all fittings in the outboard cylinder and adjust to point towards the butt end of the
cylinder. Attach the hoses as specified in the Parts Section. Slide the cylinder into the draft
beam from the outside of the draft beam and attach cylinder to the draft beam with clevis pin and
rollpins.
(ASM-C-0076)
DRAFT BEAM MOUNTING
Pull the inboard cylinder piston rod down to the extreme extended position. Slide the draft
beam under the cylinder
Using the inboard cylinder as a pivot point, slide the draft beam under the tractor and install
draft beam pin. Align hole in draft beam pin with holes in mainframe boss and install capscrew
and nylock nut.
(ASM-C-0078)