Tiger SIDE ROTARY JD6110-30M/R T4F, Mounting And Operating Instructions

Page: 41 / 202

ASSEMBLY
Assembly Section 2-11
CABLE CONTROL LEVER STAND
On the corner cab post, mark a point at 1-3/8” from the windshield and 22-1/2” from the floor;
then cut a 3/4” diameter hole through the outer plastic shell. This will expose a threaded steel
boss to attach the control box support bracket.
The rear corner of the cable control stand is placed
approximately 6-1/4” from the edge of the mat. The front
edge of the stand is up against the corner cab post and the
door sill lip of the mat. Before you mark or drill any holes,
check for support plates or wires under the mat and the cab
floor. NOTE: Cutting into plates or wires makes more work
for everyone and could be dangerous. When you know
where the wires/plates lie, mark one of the mounting holes.
Drill a 3/8” hole through the mat and through the floor of
the cab. Next, lift the mat up and mark the other two holes
on the cab floor. Drill the holes through the floor. Mark the
mat and drill the other two 3/8” holes. Use a 1” hole saw
and cut a 1” hole through the mat over each 3/8” hole. Secure the stand to the floor with the
spacers, capscrews and nylock nuts pro-
vided.
Secure cables and wires from the control
stand with zip ties and route past the right
side of the driver’s seat. Drill a 2 1/4” diame-
ter hole in the triangular area behind the
driver’s seat. Drilll a hole to the outside rear
of the tractor.
Wrap the cables with the 6” split hose at
the point they pass through the hole, and
secure the zip-ties. Apply RTV sealer in and
around individual cables and split hose,
inside and outside of the cab for a water tight seal. Install upper support bracket from cab post to
the control lever stand.
(ASM-JD CBL MNT-0002c)