Tiger SABER BOOM JD6145-55M/R T4F, Mounting And Operating Instructions

Page: 49 / 266

ASSEMBLY
Assembly Section 2-17
JOYSTICK CONTROL MOUNTING
Mounting the joystick control requires that the right armrest be modified and an
additional bracket attached to accommodate the joystick. The armrest must be removed by
sliding off the plastic cover and removing the capscrew from the lower right side of the seat.
This will leave the armrest loose so it can be removed. Once the armrest is removed, place
the joystick holder under the armrest, so the indentation on the outside of the armrest is
lined up with the hole in the armrest bracket which the capscrew will need to pass through.
Once they are lined up, mark the armrest where the hole passes through the armrest
bracket. A 1/2” hole must be drilled through the armrest so that the bracket can be
secured. After the initial 1/2” hole is drilled, on the inside of the armrest the hole must be
cut to a larger diameter up to the metal plate in the armrest, so that a spacer and hex nut
can be fastened to the capscrew which will secure the bracket. Install the armrest bracket
on the armrest with the hardware shown in the Parts Section. Once the bracket is installed,
re-attach the armrest to the seat using the existing hardware previously removed. Then
install the joystick in the bracket with the machine screws shown in the Parts Section.
Route the lift valve wires from the switchbox through the cab and out the back window.
Cover with conduit and secure with ties or clamps as necessary.
(
ASM-JD-0082)