Tiger SABER BOOM JD6145-55M/R T4F, Mounting And Operating Instructions

Page: 42 / 266

ASSEMBLY
Assembly Section 2-10
SWITCHBOX WIRING
Power for the switchbox is accessed through the port located on the right rear of the cab.
A John Deere plug is used, part number RE67651. DO NOT connect the plug to the cab port
until the wiring is completed. The wires in the plug are colored RED, BLACK and ORANGE.
The RED wire will always be hot, so it needs to be capped. Attach connector 34538 to end
of RED wire and tape wire back on itself. The BLACK and ORANGE wires are hot when
tractor key is turned to “on.” Connect the BLACK wire of the plug to the BLACK wire from the
switchbox. Then connect the ORANGE wire of the plug to the RED wire from the switchbox.
IMPORTANT: In some cases the red and orange wires may be switched. ALWAYS test
the wires to be certain which wire is which.
The two GREEN wires must be connected to the neutral safety wire by cutting the neutral
safety wire and connecting one GREEN wire to one end and the second GREEN wire to the
other. Refer to the switchbox schematic and wiring diagram for additional information.
The Neutral Safety wire is a brown wire located under steering column. Cut a slot in the
right side of column to access, WATCH OUT for existing wires.
After connecting the power to the switchbox, route the white wire along the cables or
wires to the solenoid valve.
(ASM-JD-0245)
WEATHER-PACK / METRI-PACK ASSEMBLY
These instructions apply to both Weather-Pack and Metri-Pack connectors.
NOTE: Use the specific tool for the type of connector you are assembling.
(ASM-C-0009)