Tiger NH TS100-135A, Mounting And Operating Instructions

Page: 8 / 20

PAGE - 8
MOUNTING INSTRUCTIONS
Please rea and understand the instructions and schematics completely before
beginning assembly.
Parts and drawings may vary slightly due to the variety of tractor makes and models.
The mounting kit you receive should be correct for your application. If questions arise
please contact your local dealer or Tiger Service as needed.
Lay out all loose parts on a clean surface for easy identification. Part numbers and
descriptions can be found in this manual and other information received with ypur par-
ticular unit. Any shortages should be reported immediately.
The following assembly instructions are based on the assumption a Tiger mower is
already mounted on the tractor. Variations may occur in parts and assembly onto other
makes and models.
1. Mount the control valve stand within easy access of the operator (usually
mounted to the existing mower control valve stand).
2. Mount the two - spool control valve onto the control valve stand. Install the 1/2”
pressure and return hoses as shown on the schematic. This will maintain oil
containment until assembly is complete. Note: (If your tractor has a closed center
hydraulic system, it will be necessary to a closed center plug in the control valve).
Use teflon tape on all N.P.T. fitting and joints.
3. Mount the sweeper mounting frame onto the front of the tractor. Secure the frame
using lockwashers and capscrews provided. Be sure to use loctite on mount
bolts.
4. Position the swing assembly in front of the mounting frame as shown in the parts
breakdown section of this manual.
5. Turn the leveling bolts “A” and “B” all the way in, see figure A.
6. Remove the two 7/8” x 3” pins from the swing assembly mounting ears. Raise the
swing assembly and align the holes in the swing assembly mounting ears with the
holes inthe tractor frame mounting ears.
7. Insert 7/8” x 3” pins and secure with cotter pins.
8. Position the brush head asembly in front of the swing assembly as shown in the
parts breakdown section.
9. Remove the nuts and washers from the mounting bolts in the front plate of the
swing assembly.
10. Raise the back of the brush head frame and align the center bolt holes. Insert
the center hex head bolt and secure with the lockwasher and nut. Align the
slotted hole on each side of the center bolt, insert carriage bolts and secure with
flatwasher, lockwasher, and nut. These three brush head mounting bolts must
be left loose enough to allow for leveling.