Tiger JKT-B10U, Operating Instructions Manual

Page: 23 / 170

23 23
English
Note
●
The Timer function is not available in the following
cases.
•
When the “Quick” or “Mixed” menu is selected
•
When the preset time is less than that indicated
in the following table (The times in the table
below also apply to rinse-free rice.)
Menu Minimum preset time
Plain 1 h 10 min
Ultra 1 h 30 min
Jasmine 45 min
Brown 1 h 25 min
Porridge Cooking time + 1 min
Oatmeal
(Steel cut)
55 min
•
When “0:00” is blinking on the display
●
If the Keep Warm lamp is on, press the [Cancel]
key to turn off the lamp. (The Timer function is not
available while the Keep Warm lamp is on.)
●
If you do not operate the rice cooker within about
30 seconds after pressing the [Timer] key, an
alarm (3 beeps) will sound.
●
If the [Timer] or [Start/Rinse-free] key is pressed
while the rice cooker is in a state where the Timer
function is not available, an alarm (3 beeps) will
sound.
5
Use the [Hour] and
[Min] keys to set the
desired completion
time.
Press the [Hour] key to change the set time
in 1-hour increments. Press the [Min] key to
change that time in 10-minute increments.
Hold down the corresponding key to change
the time more rapidly.
Blinks
•
The time is displayed in a 12-hour format.
Note
●
Do not set the timer to more than 12 hours, as it
may result in spoiled rice.
●
Check whether “AM” or “PM” currently displayed.
6
Press the [Start/Rinse-
free] key once.
When cooking rinse-
free rice, press the key
twice.
The Timer lamp will turn on and the Timer
function is set.
•
Rinse-free rice can be cooked under the
“Plain”, “Ultra”, and “Porridge” menus.
For normal cooking
When you selected the “Plain” menu, a one-
short, one-long beep alarm will sound. In
other menus, only a one-beep alarm will
sound.
On
On
When cooking rinse-free rice
“Rinse-free” appears on the display.
When you selected the “Plain” menu, a
one-short, one-long, another one-short
beep alarm will sound. In other menus, a
one-long, one-short beep alarm will sound.
On
On
•
If you make a mistake or otherwise want to
reset the timer, press the [Cancel] key and
repeat the procedure from step
2
on p.22.