Tiger JD 5520, Mounting And Operating Instructions

Page: 30 / 222

Assembly Section 2-4
ASSEMBLY
CABLE CONTROL LEVER STAND
On the corner cab post, mark a point at 1-3/8” from the windshield and 22 ½” from
thefloor; then cut a ¾” diameter hole through the outer plastic shell. This will expose a threaded
steel boss to attach the control box support bracket.
The rear corner of the cable control stand is
placed approximately 5 ¾” from the edge of the mat.
The front edge of the stand is up against the corner
cab post and the door sill lip of the mat. Before you
mark or drill any holes, check for support plates or
wires under the mat & the cab floor. NOTE: Cutting
into plates or wires makes more work for everyone
and could be dangerous. When you know where the
wires/plates lie, mark one of the mounting holes. Drill
a 3/8” hole through the mat and through the floor of
the cab. Next, lift the mat up and mark the other two
holes on the cab floor. Drill the holes through the
floor. Mark the mat and drill the other two 3/8” holes.
Use a 1” hole saw and cut a 1” hole through the mat
over each 3/8” hole. Secure the stand to the floor with the spacers, capscrews and nylock
nuts provided.
Cut a 1 ¾” hole in the floor to route the cables and wires through. It needs to have a
¼” clearance for the trim lock. Before you mark or drill any holes, check for support plates
or wires under the cab floor.
NOTE: Cutting into plates or wires makes more work
for everyone and could be dangerous. Look under the
floor for cables and plates that you need to avoid. The
hole should be approximately 4 ½” from the door sill
and 4 ¾” from the lip of the mat under the console.
Install the trim lock around the metal edges of the hole,
then route the control cables and wires through the
hole.
Next, wrap the cables with the 6” split hose at
the point they pass through the hole, and secure the zip-ties. Apply RTV sealer in and
around individual cables and split hose, inside and outside of the cab for a water tight seal.
Install upper support bracket from cab post to the control lever stand.