Tiger CS7-200H, Owner'S Manual

Page: 8 / 20

Tiger Chipper Shredder CS7-200H & CS7-270H Owners Manual (PART CS-M) page 8
When this equipment is stopped for servicing, inspection, or storage, make sure the spark plug wire is disconnected
from the spark plug. Allow the machine to cool before making any inspections, adjustments, etc. Maintain the
machine with care and keep it clean by blowing, brushing or wiping it down.
Store the machine out of the reach of children and where fuel vapor will not reach an open flame or spark. For
extended storage periods, run the unit dry of fuel. Always allow the machine to cool before storing.
Chipper Blade Re - sharpening
When the chipper blades are blunt, the machine will lose its self - feeding action and the material has to be pushed
in. Often the material will come out in long strips.
The chipper blades need to be turned over to present a new edge if there is one, or remove for sharpening. To
remove the blades, open the discharge chute. With a 13 mm ring spanner remove the blades. Be careful not to drop
the nuts, bolts or blades into the chipper.
The chipper blades should be sharpened on a surface grinder or replaced with new ones. Make sure there is plenty
of coolant used when grinding, to avoid softening of the material. The cutting angle is critical for the performance of
Maintenance
Service and Maintenance Schedule
Frequency
Component Maintenance Required
Refer to
Engine
Operators
Manual
Before
each Use
Every
8hrs
Every
25hrs
Every
50hrs
Engine Oil Change¹
✓
Fuel filter Replace
✓
Spark Plug Check Condition & Gap
✓
Engine Oil Check / Fill
✓
Fuel Tank Check / Fill
✓
All internal &
external nuts &
bolts
Check Tightness
✓
Tyre Pressure Check
✓
Chipper Anvil
Check Clearance & re - Torque
to 75 ft - lbs²
✓
Chipper Blades
Check Sharpness & re - Torque
to 25 ft - lbs ²
✓
Shredder Blade Check Condition
✓
Entire Machine Clean
✓
Drive Belt Check
✓
Belt Tension Check
✓
Belt/Pulley
Alignment
Check
✓
Grease Nipple Lube
✓
(¹) Perform more frequently under extremely dusty conditions
(²) Perform more frequently when chipping dry or dirty wood