Tiger CNH T6010-80, Operating Instructions Manual

Page: 64 / 240

Assembly Section 2-32
ASSEMBLY
FINAL PREPARATION FOR OPERATION
Place operators safety and operation decals on the steering column and side
counsel where they are clearly visible to the operator. These decals should be
understood by each operator of the machine in conjunction with the safety and
operation section of this book. The decals are to remain in good condition as a
reminder to the operator, and should be replaced if damaged.
Finally, all bosses, pins and pivot points will need to be greased as instructed
in the maintenance section of this manual. The hydraulic reservoir can also be
filled with the recommended fluid (see maintenance section) and the filter installed
in the top of the tank. Double check all fittings and fasteners BEFORE starting
tractor. Also secure any loose hoses together with zip ties and wrap with split
hoses where friction may occur on the hoses.
BEFORE starting or operating the tractor you must read and
understand the safety and operation sections of this manual
completely.
BE SURE THE BALL VALVES ARE OPEN! Start tractor and allow
instruments to stabilize. Using a piece of paper or cardboard as noted in the
safety and maintenance sections, check all fittings and connections for hydraulic
leaks.
If a leak is found, you must shut down the tractor, set the cutter on the ground.
Before attempting to fix the leak, you must actuate the lift valve handles several
times to relieve any pressure in the lines.
Before operating the mower , the cutter head and boom should be slowly
moved throughout the full range of motion. Watch for any condition that would
cause pinching or excess stress on the hoses. The steering and front axle travel
should also be carefully moved through their full range of motion. If any condition
occurs in which the hoses contact the tires, the steering and / or front axle travel
may need to be limited as described in the tractor operators manual. This should
also be done if the tires rub, or are extremely close to any other part of the mower
such as the hydraulic tank or draft beam. This may include adding shims, or
adjusting stop bolts in the tractor front to solve the problem. While checking
motion, you should also check that the control circuits are connected according to
the operators decal for the valve handles.
MOWER TESTING
Take the tractor to a place free of loose objects on the ground. Operate the
cylinders through their full range of motion again, to clear the lines of air. Follow
the instructions in the operation section to operate the mower. Vibration of the
mower should be minimal at all times. After a 5 minute test run, the knife bolts
should be retorqued and once again after the first few hours of operation.
If any parts of this assembly section, or any other section of this
manual are not clearly understood you must contact your dealer or
the address on the front of this manual for assistance!