4-12
FEATURES
BILGE (Bilge Pump)
This switch operates the bilge pump to remove excess water from the bilge
area of the boat manually. When the top of the switch is pressed, the bilge
will turn on. When the bottom is pressed, the bilge will turn off.
Your Tigé boat is equipped with an automatic bilge pump which detects
excess water accumulation and will turn the bilge pump on automatically.
The switch does not have to be on for the automatic system to work. This
switch can also be used to test the bilge pump, by listening to hear that the
pump is operating. It may not pump water unless water is present. Do not
operate the bilge pump continuously when it is dry.
Inspect the bilge area frequently for evidence of excessive water. Continuous
operation of the bilge pump can mean there is excess water in the bilge. Test
the bilge pump at regular intervals. Debris can also prevent the pump from
operating or make it operate continuously. Make sure no debris is blocking
the bilge pump float. See your Tigé Dealer if you have any questions.
BLOWER (Engine Compartment/Bilge Area Blower)
This switch operates the engine compartment ventilation blower to remove
explosive fumes from the area. When the switch is pressed, the blower will
turn on. When the opposite end is pressed, the blower will turn off. The
blower must be operated for a minimum of four minutes before starting the
engine. Also, the blower should be operated continuously when at idle or
running at slow speeds.
CRUISE CONTROL ON/OFF (Tigé SpeedSet)
This switch supplies power to operate the Tigé SpeedSet. When the switch
is pressed (on), power is supplied for the cruise control, when the opposite
end is pressed, the power will turn off.
!
WARNING
FIRE/EXPLOSION HAZARD
Gasoline vapors are highly explosive when exposed to open flame or spark
resulting in death or serious injury. Run blower for at least four minutes
BEFORE turning on any electrical devices or starting the engine.
CTSY LTS (Courtesy Lights)
This switch operates the courtesy lights. When the switch is pressed, the
lights will turn on. When the opposite end is pressed, the lights will turn off.
DOCK LTS (Docking Lights, optional)
This switch operates the docking lights. The docking lights are to be used for
docking only; DO NOT use them while cruising. When the switch is pressed, the
lights will turn on. When the opposite end is pressed, the lights will turn off.
Emergency Stop Switch
The emergency stop switch will stop the engine when the lanyard is pulled
far enough to disconnect the clip from the switch. Attach the lanyard to the
boat operator whenever the engine is running, but be aware of loss of engine
power if the switch is activated.
If the operator is thrown from the seat, or moves too far from the dash, the
lanyard will disconnect the clip from the switch, shutting off the engine.
To attach a lanyard, connect the clip to the emergency stop switch and the
hook to a strong piece of clothing on the operator, such as a belt loop.
!
WARNING
LOSS OF CONTROL AND UNSAFE BOAT HAZARD
An emergency stop switch system that is not used or does not function
properly can cause death or serious injury. DO NOT operate the boat if the
emergency stop switch system does not function properly.
4-13
Summary of Contents for Multi-sport Inboard Boat
Page 13: ...1 20 INTRODUCTION 1 21 ...
Page 91: ......
