Thunder ATX Motherboard
Page 12
Installation step:
1. Turn off the power of your system and remove its cover;
2. Locate the ZIF socket and open it by first pulling the lever sideways away from
the socket then upwards to a 90-degree angle;
3. Insert the CPU with correct orientation
(The CPU has a corner pin for two of the four corners, that the CPU only fit in the
orientation.)
4. Once completely inserted, pull down the socket
’
s lever to horizontal and make
sure the CPU is firmly locked in the socket.
2.4.14 CPU Fan Connector
CPU Fan cable plug in the 3-pin CPU Fan connector onboard.
Pin1
Sense
Pin2
+12V
Pin3
GND
2.4.15 Internal Audio Connectors(CD, AUX, 4-pin Modem)
These connectors allow you to receive stereo audio input from sound sources such
as a CD-ROM or MPEG card. The Modem connector allows the onboard audio to
interface with an voice modem card with a similar connector. It also allows the
sharing of mono_in (such as a phone) and mono_out(such as a speaker) between
the onboard audio and the voice modem card.
T-815E+S Classic model:
CDD1 (CD Input)
1 (1: Left Audio Channel; 2,3: Ground; 4: Right Audio Channel)
CDD2 (CD Input) 1
(1,3: Ground; 2: Right Audio Channel; 4: Left Audio Channel)
AUX(Auxiliary Input) 1
(1: Left Audio Channel; 2, 3: Ground; 4: Right Audio Channel)
TAD (Telephony Input) 1
(1: Mono_in; 2,3: Ground; 4: Mono_out)
T-K133+S / T-K133+MS model:
J32 (CD Input)
1 (1: Left Audio Channel; 2,3: Ground; 4: Right Audio Channel)
J24 (CD Input)
1 (1,3: Ground; 2: Right Audio Channel; 4: Left Audio Channel)
J25 (Auxiliary Input)
1 (1: Left Audio Channel; 2, 3: Ground; 4: Right Audio Channel)
J23 (Telephony Input)
1 (1: Mono_in; 2,3: Ground; 4: Mono_out)
2.4.16 VGA Connector
(excluded from model T-815E+PS Classic / T-K133+S)
The VGA connector allows you to connect a standard monitor through the
provided VGA cable with mounting bracket. Connect the cable to this header and
mount the bracket to the case on a free expansion slot.
1
CPUFAN
