Page 11
Thunder ATX Motherboard
2.4.10 BIOS
The motherboard flash BIOS provides users with more flexibility in upgrading their
motherboards. The flash BIOS can be easily reprogrammed via software.
2.4.11 Wake-On-LAN Interface
This connector connects to a LAN card with a Wake-On-LAN output. The connec-
tor powers up the system when a wakeup signal is received from the network.
2.4.12 Front Panel Function Connector
The front panel integrates: Power On, IDE LED, Keylock, Reset Switch, Sleep,
ExtSMI, Speaker, etc...
The connector pin out are described as the figure below:
1 ATXPWRON
2
Reset Con
3
Ground
4
Ground
5
VCC
6
Sleep
7
IDE LED
8
Ground
9
No Connect
1 0 EXTSMI
1 1
PWR LED
1 2 Ground
1 3
Ground
1 4 Speaker
1 5
Ground
1 6 Ground
1 7
Keylock
1 8 Ground
1 9
Ground
2 0 VCC +5V
2.4.13 CPU Socket
The T-815E+S Classic motherboard provides a ZIF Socket 370. The CPU that comes
with the motherboard should have a fan attached to it to prevent overheating. If it is
not so, purchase a fan before you turn on your system.
The T-K133+S / T-K133+MS motherboard provides a Socket A for install AMD K7
CPU. The CPU that comes with the motherboard should have a fan and heatsink
attached to it to prevent overheating. If it is not so, purchase a fan and heatsink
before you turn on your system.
Notice !!!
Be sure that there is a sufficient air circulation across the processor
’
s heatsink
by regularly checking that your CPU fan is working. Without sufficient circu-
lation, the processor could be overheated and it may damage both the processor
and the motherboard. You may install an auxiliary fan, if necessary.
PWR ON
IDE LED
KEYLOCK
RESET
SLEEP
EXTSMI
SPEAKER
