12
16
5
Outlet
Inlet
NOTICE
- THERE ARE RAISED
ARROWS ON THE BYPASS
ASSEMBLY INDICATING
DIRECTION OF WATER FLOW
Inlet
*
Check Valve
Outlet
*NOTE
Check local plumbing codes in
regards to requirements for
use of Check Valve or back
flow prevention or vacuum
breaker
Cold (Raw water)
Cold (Filtered water)
Cold (Raw water)
*Check Valve
Water Heater Water Softener
AIO
Filter
In
In Out
n
I
Out
Out
Cold (Soft Water)
Hot (Soft Water)
To Outside Faucet
CAUTION!
Never insert drain line
directly into a drain, sewer line, or trap.
Always allow an air gap between the drain
line and the wastewater to prevent the
possibility of sewage being back-siphoned
into the conditioner.
NOTE
Waste connections or drain
outlet shall be designed and
constructed to provide for
connection to the sanitary
waste system through an
air-gap of 2 pipe diameters
or 1 inch (22 mm) whichever
is larger.
INSTALLATION
Connect Filter to the house plumbing. Any solder joints near the valve must be done before connecting any piping to the valve. Always leave at least
6” (152 mm) between the valve and joints when soldering pipes that are connected to the valve. Failure to do this could cause damage to the valve.
Correct Installation of the Check Valve:
Install 1” check valve on inlet of bypass valve. The check valve needs to be installed at the highest possible
level of the plumbing line to avoid air trap. Please see an example below:
16
5
Outlet
Inlet
NOTICE
- THERE ARE RAISED
ARROWS ON THE BYPASS
ASSEMBLY INDICATING
DIRECTION OF WATER FLOW
Inlet
*
Check Valve
Outlet
*NOTE
Check local plumbing codes
in regards to requirements
for use of Check Valve or
back flow prevention or
vacuum breaker
Cold (Raw water)
Cold (Filtered water)
Cold (Raw water)
*Check Valve
Water Heater
Hot (Soft Water)
Water Softener
AIO
Filter
In
In Out
In
Out
Out
Cold (Soft Water)
To Outside Faucet
the valve and joints when soldering pipes that are connected to the valve. Failure to do this could cause damage to the valve.
Correct Installation of the Check Valve:
Install 1” check valve on inlet of bypass valve.
The check valve needs to be installed at the highest possible level of the plumbing line to
avoid air trap. Please see an example below:
CAUTION!
Never insert drain line
directly into a drain, sewer line, or trap.
Always allow an air gap between the
drain line and the wastewater to
prevent the possibility of sewage being
back-siphoned into the conditioner.
NOTE
Waste connections or drain
outlet shall be designed
and constructed to provide
for connection to the
sanitary waste system
through an air-gap of 2
pipe diameters or 1 inch (22
mm) whichever is larger.
Connect Filter to the house plumbing. Any solder joints near the valve must be done before connecting any piping to the valve. Always leave at least 6” (152 mm) between
