![background image](http://html1.mh-extra.com/html/tidel/tacc-vi/tacc-vi_operators-manual_1114361026.webp)
24
Tube Vending Module
Loading The Operating Cash
Each one of the 8 columns will hold 11 tubes each.
Step 1:
All coins must be placed in tubes before loading into the
columns.
Do not place tape over the end of the tube.
Tape will cause jams.
NOTE:
If loose coins are to be loaded into the tubes, end caps for
the tubes can be purchased.
Step 2:
Bills loaded into the tubes should be folded lengthwise and
inserted into the tubes.
NOTE: Approximately 30 bills can be placed in a tube, however,
bills that are “packed” into a tube will be difficult to remove
and will not lay flat in the cash register.
Step 3:
Select LOAD TUBES from the Main Screen and enter a valid
PIN when the prompt appears.
Step 4:
The Tube Loading Gate will retract, allowing tubes to be
placed in the columns.
Step 5:
Load the tubes, closed end 1st, to prevent coins from
falling out of the tube and into the columns, causing jams.
X
The lock above the tube loading holes provides access
to the tube vending mechanism for service.
X
This key must be available for servicing the Tube
Vend Module.
Summary of Contents for TACC-VI
Page 1: ...450 0447 001 Rev C TACC VI...