TIC Audio Wifi Airplay2 installation instruction
TIC Audio
–
Wifi Airplay2 installation instruction v1.4
2
This manual is applicable for the TIC Wifi Airplay2 family, including the following compatible models:
-
Wifi Airplay2 Amplifiers: AMP88; AMP99; AMP150; AMP200 ; AMP210
-
Wifi Airplay2 Receiver and Transmitter: WRB12
-
Wifi Airplay2 Speakers: WB3; WB6; WB16; WBP10; WBP11
Table of contents:
page
1.
Introduction
2
2.
Wifi setup
3
3.
Bluetooth input setup
3
4.
Wired inputs
3
5.
Equalizer / tone control
3
6.
Streaming music/multi-room setup
4
7.
Important notes
4
1.
Introduction
-
In the below sections, when instructed to press a specific button on the TIC device, you can either aim the remote control at the speaker/amplifiers
and press the button
or
press the respective button on the speaker/device itself if the specific button is available.
-
Not every button mentioned is available on each individual speaker/device
-
Please note the position of the IR receiving node on the speaker/device when aiming the remote control. The performance of the remote control
may degrade if the remote control is not aiming directly at the node or if strong sunlight is interfering with the signal.
-
Range of the remote control is max 10 meter. If the signal is not received properly please move closer.
-
A single remote control can control any compatible TIC speaker/device. Aim the remote control carefully if multiple speakers are placed in close
proximity.
-
Volume control can be individually customized for each speaker via the remote control, via the music/video application (e.g. Spotify, Tune-in etc.) or
on the device itself (if volume button is available).
