OM_UFAT_0308RevA
User Friendly Anti-Tip Owners Manual
USER-FRIENDLY ANTI-TIPS
13
9.
I
WARNING: Before sitting in the chair, make sure that the anti-
tips are operating properly. To do this, place the chair on a level
surface and engage the anti-tips. Tip the chair backward until the
weight of the chair is supported by the anti-tips and rear wheels.
Apply sufficient pressure to ensure that the anti-tips are operating
properly.
If you ignore this warning, you may fall, tip over or lose
control of the wheelchair and seriously injure yourself or others or
damage the wheelchair.
10. Check the toe-in/toe-out and adjust as needed.
Mounting the User-Friendly Anti-Tip
(TX)
I
WARNING:
Mounting the user-friendly anti-tip receiver must be performed by
an authorized TiLite dealer or qualified technician.
If you ignore this
warning, you may fall, tip over or lose control of the wheelchair and
seriously injure yourself or others or damage the wheelchair.
I
WARNING:
Do not disassemble the anti-tip mounting assembly (see Figure 12).
If you ignore this warning, you may fall, tip over or lose control of
the wheelchair and seriously injure yourself or others or damage the
wheelchair.
Tools Needed:
• 5/32” Allen Wrench
1. Remove the rear wheels and place the frame on a level surface.
2. Without disassembling the anti-tip mounting plate from the anti-tip
receiver, align the anti-tip mounting plate with the CG brackets.
3.
I
WARNING: Make sure that the TiLite logo is visible on the
rearward side of the user-friendly anti-tip receivers as shown in
Figure 12 and that the white arrows are all aligned on the opposite
(forward) side of the anti-tip components as shown in Figure 12.
If
you ignore this warning, you may fall, tip over or lose control of the
wheelchair and seriously injure yourself or others or damage the
wheelchair.
4. Align the holes on the forward end of the anti-tip mounting plate with the
threaded holes on the upper and lower halves of the CG bracket. Select
two threaded holes on the upper half and two threaded holes on the lower
half of the CG bracket that are not already in use to secure the camber
clamp to the CG bracket. Insert the four Allen Screws through the lock
washers and anti-tip mounting plate and into the four unused threaded
holes in the CG bracket.
5. Securely tighten the Allen Screws that secure the anti-tip mounting
plate to the CG bracket.
6. Adjust the height of the anti-tip as described under “Adjusting the Anti-
Tip” above.
Figure 12
Mounting the Anti-Tip to the TX
Anti-Tip
Mounting Plate
Anti-Tip
Receiver
Lock Washers
Allen Screws
CG Brackets