User Friendly Anti-Tip Owners Manual
OM_UFAT_0308RevA
USER-FRIENDLY ANTI-TIPS
10
7.
I
WARNING: Make sure that the TiLite logo is visible on the
rearward side of the user-friendly anti-tip receivers as shown in
Figure 9 and that the white arrows are all aligned on the opposite
(forward) side of the anti-tip components as shown in Figure 9.
If
you ignore this warning, you may fall, tip over or lose control of the
wheelchair and seriously injure yourself or others or damage the
wheelchair.
8. Securely tighten all Allen Screws.
9. Reinstall the rear wheels.
10. With the wheelchair standing upright on a level surface, engage the
anti-tip as described under “Engaging the Anti-tip” above.
11. Adjust the height of the anti-tip as described under “Adjusting the Anti-
Tip” above.
12.
I
WARNING: Before sitting in the chair, make sure that the
anti-tips are operating properly. To do this, place the chair on a level
surface and engage the anti-tips. Tip the chair backward until the
weight of the chair is supported by the anti-tips and rear wheels.
Apply sufficient pressure to ensure that the anti-tips are operating
properly.
If you ignore this warning, you may fall, tip over or lose
control of the wheelchair and seriously injure yourself or others or
damage the wheelchair.
13. Check the toe-in/toe-out and adjust as needed.
Mounting the User-Friendly Anti-Tip
(TRA and YRA)
I
WARNING:
Mounting the user-friendly anti-tip receiver must be performed by
an authorized TiLite dealer or qualified technician.
If you ignore this
warning, you may fall, tip over or lose control of the wheelchair and
seriously injure yourself or others or damage the wheelchair.
I
WARNING:
Do not disassemble the anti-tip mounting assembly (see Figure 10).
If you ignore this warning, you may fall, tip over or lose control of
the wheelchair and seriously injure yourself or others or damage the
wheelchair.
NOTE:
Unless you ordered user-friendly anti-tip when you originally
ordered your TiLite TRA or YRA, you will need to order replacement Allen
Screws when ordering user-friendly anti-tips.
Tools Needed:
• 3/16” Allen Wrench
1. Remove the rear wheels and place the frame on a level surface.
Figure 10
Mounting the Anti-Tip to the TRA and YRA
Anti-Tip
Mounting Plate
Anti-Tip
Receiver
Camber Tube
Camber Mounts
Camber
Tube Clamp
Allen Screws
Axle Plate