22. Install EZ Connector on servo horn.
24. Locate Vecro and cut it into two pieces. Attach the
vecro to battery pack and attach the other halves
of vecro to the fuselage as shown.
25. Refer to manufacturer's Receiver and ESC manual
then connect all connectors properly. The ESC
and RX are located between battery and motor.
You might need two servo extensions at this step.
Install the switch on fuselage as shown. Thread
the antenna though fuselage and explode at least
5"(10cm) in length out of of fuselage.
26. The attached two pictures are the examples for
using ESC-30 and auto cut-off.
23. Insert the pushrod through the EZ connector,
make sure elevator is level with the tail then secure
the servo horn and set screw when servo is in
neutral position.
ASSEMBLY / SERVO
Rx
Motor
ACE
ESC-30
0N
OFF
Batt
Sw
7.2-8.4V Battery
ACE R/C
27
NARROW BAND
MHZ
TR-402A
4CH AM RECEIVER
CH.2
BATT
CH.1
CH.4
CH.3
BEC
INPUT VOLTAGE:7.2-8.4V
CONTINOUS CURRENT :30A(MAX)
M-
Auto Cutoff
B-
SW
B+
M+
START
OFF
ON
ACE R/C
27
NARROW BAND
MHZ
TR-202A
4CH AM RECEIVER
CH.2
BATT
CH.1
7.2-8.4V Battery
