11. Locate Elevator Control Horn (Back Plate, Control
Horn Base, 2 x 25mm Screw, Nylon Horn).
Position Back Plate on elevator then drill 3/64"
(2mm) holes.
12. Secure and install the control horns as shown.
13. Locate the Y Pushrod then bend the wire as
required in the photo.
14. Insert Y Pushrod through fuselage and exit two
ends at two pushrod exit holes. Thread Clevises
on two threaded pushrod ends then connect to the
elevator control hor ns. Slice two pieces of
furnished tube then apply on clevises to prevent
clevis snapping off when in flight.
Motor / Prop Installation
15. Locate Motor, Motor Mount, Folding Prop and
Screws as shown.
16. Apply very very little CA glue to keep motor mount
on motor. Be careful do not apply any glue at
mounting holes and motor shaft. Trail fit motor in
fuselage, sand the contact area if necessary.
When satisfied, apply very thin epoxy on motor
mount then secure motor in fuselage with two 2.5
x 5mm Sink Screws.
ASSEMBLY / TAIL / MOTOR
