7
12.Lubricate the drive shaft is important. Remove
the shaft by unscrewing the adaptor. Note to exam
the shaft then clean and apply new grease every 10
runs.
9.Place the boat in water gently to test run the boat.
Check if water flow out from the port. If not then drive
it back to the pier or shore to exam the water line.
This is very important that motor will overheat and
burn if water cooling is not enough. Trim the boat
and make sure the boat runs straightly.
8.Initial setting of rudder is about 3-degree to the left
when servo is in the neutral position. This is to
correct the prop walk.
10.The
can run at full power
speed for about
minutes and top speed may
reach 22mile/hr if using the suggested 2200mAh
Lipo Battery (No.2814). Always watch the running
time and do not run too far at the last as battery may
out of power any time.
Desperado JR. OBL
4~5
11. Always get back to the pier with the power as it is
not good to run out of power then retrieve the boat
from the pond or lake. Once out of power, do not be
nervous and decide the shortest distance to the
shore, the battery still has some power in it, you may
stop the motor for couple seconds then run the boat
again, it can move a short distance. You may repeat
this for several times until the boat reach the shore.
7.
Make sure the propeller rotates counter-clockwise,
if not then switch any two of the wires of the
brushless motor to the connectors of controller.
RADIO
Summary of Contents for Desperago Jr. 5126
Page 10: ...10 MOTOR F F No 2375 OBL 29 19 15M...
Page 12: ...12 SPEED CONTROLLER...
