6
1.Locate two stands and beams. Assemble the stand
as illustrated. Locate the foam tapes, then apply on
the top side of the front and the rear stand, this is to
protect the bottom surface of the hull.
2.Now you can place the
on the stand.
Open the hatch cover with your index finger at the
black fin.
Desperado
4.
Install a mini servo in place as shown with two
3x6mm self-tapping screws. Adjust the clevis and
make sure the servo and water rudder are in the
position as shown in step 8.
6.
With transmitter on, install the suggested 3S1P
2200mAh Lipo Battery in place and connect the
wires properly.
Make sure the motor is not rotating when transmitter
is in neutral position. Adjust the trim knob if
necessary.
5.Install the receiver and thread the antenna through
the antenna mount.
Refer to radio instruction manual and well connect
the servo wire and controller wire.
Always use care
and keep away from the propeller when you connect
the battery wires. Remember that always transmitter
on first then connect the battery; disconnect the
battery first and turn off the Transmitter at last.
ASSEMBLY
3.Now you can see the radio case. Unlock the case
cover at the indicated position. Make sure to lock
and seal the cover securely after the assembly
adjusting or battery change.
Summary of Contents for Desperago Jr. 5126
Page 10: ...10 MOTOR F F No 2375 OBL 29 19 15M...
Page 12: ...12 SPEED CONTROLLER...
