Thrane&Thrane TT-3020C, Configuration Manual

Page: 45 / 96

Configuring the VMS behaviour
Transceiver Configuration
9-Nov-00 Page 4-11
4.1.9 Disable Send LED on position report TX
Please notice that this command is not supported in the TT-
3020C SOLAS Fishery Transceiver nor in the TT-3028CM Dual
Mode SOLAS Fishery transceiver.
This entry is used to configure that the transceiver does not light up
the Send LED when transmitting position reports.
Usually the Send LED will lit while the transceiver is transmitting
but by setting this entry to
Yes the transceiver will only turn on the
Send LED when sending messages, loggi ng into/out of the ne t-
work, during performance verification test, distress alert etc.
The functionality is configured by entering 26 in the fishery com-
mand entry.
4.1.10 Stop button initiates position report
The stop button can be configured for two different purposes. Ei-
ther it will cause the transmission of a manually initiated position
report or it will set the transceiver in In-Port mode where the num-
ber of position reports are reduced.
The feature is configured by entering 27 in the fishe ry command
entry.
4.1.10.1 Transmit manual initiated position report
If this entry is configured to Yes the Stop button on the front panel of
the transceiver (Figure 6 or Figure 8) can be used to initiates a po-
sition report with a MEM code that indicates that it is a manual
transmitted position report.
The Stop button must be pressed for 4-5 seconds until a “beep”
sound from the transceiver. This indicates that the transceiver has
initiated a manual position report.