Stabilized Benchtop IR Light Source
Chapter 2: Safety
Page 2
CTN010315-D02
Chapter 2 Safety
The lamp comes with a switching power supply compatible with voltages from 100 to 240 VAC. There is no need
to change the fuse when selecting your regional voltage. If the user needs to change the fuse located below the AC
plug on the back of the unit, see Fuse Replacement on page 13.
SHOCK WARNING
High voltage inside. To avoid electrical shock, before powering unit, make sure that the protective
conductor of the 3-conductor power cord is correctly connected to the protective earth contact of
the socket outlet. Improper grounding can cause electric shock resulting in severe injury or even
death. Do not operate without cover installed.
WARNING
This unit must not be operated in explosive environments.
WARNING
Do Not Operate in Wet/Damp conditions.
WARNING
Do NOT look directly at the light source beam during operation. Do NOT place hand or body part in
the light beam as this may cause burning.
CAUTION: HOT SURFACE
The housing of the lamp housing can get very hot during operation.
Extensive contact may cause burning.
WARNING: HOT SURFACE
The temperature of the Globar module
will exceed 200˚C during operation. Always wait for at least
30 minutes for the module to cool down before performing a module replacement. Always wear
gloves when handling modules or bulbs.
