THORLABS PICO D, User Manual

Page: 20 / 48

20
Figure 2–9 Recommended connection of electrical power and analog signals
to PICO D.
2.5.2 Power supplies
Three external power supplies are required to run the PICO D unit. Table 2-2 lists
the required voltages, and Table 2-3 list the requirements set on the power supplies,
and finally Table 2-10 lists the pin configuration of the DC power connector. The full
pin configuration of the PICO D power and signal connectors are shown in Figure 2–
15.
Table 2-2 DC-power supply
Voltage Comments
+5 V +5 volts supply
GND (+5 V)
Return for +5V
connected to the circuit board ground
+15V +15 volts supply