50
HA0362T Rev C Jan 2017
Chapter 6
6.3
Settings Panel
When the 'Settings' button on the GUI panel is clicked, the 'Settings' window is
displayed. This panel allows motor operation parameters such as move/jog velocities,
and stage/axis information to be modified. Note that all of these parameters have
programmable equivalents accessible through the ActiveX methods and properties
on this Control (refer to the
Programming Guide
in the
APTServer helpfile
for further
details and to Section 2.3.4. for an overview of the APT ActiveX controls).
6.3.1
Moves/Jogs Tab
Fig. 6.2 Stepper Driver K-Cube - Move/Jog Settings
Moves - Velocity Profile
Moves can be initiated via the GUI panel, by using the velocity wheel (see Section
4.3.) or by entering a position value after clicking on the position display box (see
Section 5.4.). The following settings determine the velocity profile of such moves, and
are specified in real world units, millimetres or degrees.
MaxVel
- the maximum velocity at which to perform a move.
Note
The minimum velocity is locked at zero and cannot be adjusted.
