13
K-Cube Stepper Motor Controller
3.2
Mechanical Installation
3.2.1
Environmental Conditions
Location
Indoor use only
Maximum altitude
2000 m
Temperature range
5
o
C to 40
o
C
Maximum Humidity
Less than 80% RH (non-condensing) at 31°C
To ensure reliable operation the unit should not be exposed to corrosive agents or
excessive moisture, heat or dust.
If the unit has been stored at a low temperature or in an environment of high humidity,
it must be allowed to reach ambient conditions before being powered up.
3.2.2
Mounting Options
The K-Cube Stepper Driver is shipped with a baseplate, for use when fitting the unit
to a breadboard, optical table or similar surface - see Section 3.2.3.
For multiple cube systems, a 3-channel and 6-channel K-Cube Controller Hub
(KCH301 and KCH601). ) are also available - see Section 2.2. for further details. Full
instructions on the fitting and use of the controller hub are contained in the handbook
available at www.thorlabs.com.
Caution
This unit is designed for operation within normal operational limits. It is not
recommended to use this equipment outside the following limits.
Caution
When siting the unit, it should be positioned so as not to impede the
operation of the control panel.
Ensure that proper airflow is maintained to the unit.
