Thorlabs Digital Camera Quick Start Guide
Chapter 3: Setup & installation
Rev S, June 1, 2020
Page 11
3.7.3. Connections for a USB 3.0 Scientific Camera
Note:
Compact
Scientific cameras use the USB 3.0 cable for both data and
power.
To connect the camera, follow the steps below:
1. Plug the included power supply into a 100
– 240 VAC mains outlet.
2. With the power supply turned off, connect the power supply to the
POWER
connector on the back of the camera. The connector on the
camera is keyed to orient the connectors properly.
3. Connect the provided USB 3.0 cable into the mating
USB
port on the
back of the camera. The camera end of the cable will have two thumb
screws. Make sure the connector is fully inserted, and then tighten the
thumbscrews by hand into the camera housing. Connect the other end
of the USB 3.0 cable into a USB 3.0 port (USB SS) on the host
computer.
4. If external I/O signaling is required connect an 8050-CAB1 cable (not
included) to the
AUX
port.
Summary of Contents for DCC3260M
Page 1: ...Thorlabs Digital Camera Quick Start Guide ...
Page 20: ...www thorlabs com ...
