With all the resistors installed, the board should look something like this:
It's a good idea now to clean up the board & then give it an inspection to check everything you've
installed looks OK. Use the same cleaning technique that you used for R1.
Now use a magnifier glass or jewellers loupe to inspect your solder joints. Check that the contact
points on the resistors & the pads on the PCB are covered in solder. Check that the solder doesn't
short on to other tracks or pads. Excess solder can be removed using solder wick as described
previously.
MTM SimpleEQ 1206 build doc v1.3
Page 13
