22
Use
pq
or
P+/P-
to highlight the city of your choice and press
OK
to select it. You can also search
manually for a desired place by pressing the
GREEN
Change City
button. Use
pq
t
u
and
OK
to
enter. Use
P+/P-
for special characters within the keyboard. To save the name, select
Save
and press
OK
. The
RED
button is used to update the weather data and the
BLUE
button to change the unit
between Celsius and Fahrenheit.
7.7.3 IP-Setting
In this menu, you can set up or check the Internet connection. By default
DHCP
is
ON
. Normally, this
will automatically establish the connection. To test the Internet connection, select
SET
with the
pq
butttons and press
OK
. If this succeeds, a message appears and you can use the Internet functions of
this receiver. If this does not work, check the cable or router or its Internet configuration. Alternatively,
set
DHCP
to
OFF
. Then manually enter
IP Address
,
MASK
,
GATEWAY
and the DNS values with the
0
-
9
buttons. After entering these values, select
Save
and press
OK
to save.
8.0 TROUBLESHOOTING
There may be various reasons for abnormal operation of the receiver. Please check the receiver
according to the procedures shown below. If the receiver does not work properly after checking it,
please contact your local service line or dealer. Alternatively, you can send a support e-mail via our
website: www.thomsonstb.net. NEVER open or disassemble your receiver. This may cause a dangerous
situation and will void the warranty.
Symptom
Cause
Remedy
The display on front
panel does not light up.
The power adapter is not
plugged in or power of an
extension is switched OFF.
Check that the power adapter is
plugged in to the wall outlet. Make sure
power switch on the extension cable/
distributor is in ON position.
No picture or sound
Wrong connection or setting of
the Audio/Video output of the
receiver to TV.
Connect the Audio/Video output of the
receiver to TV correctly and check the
adjusted settings in the menu
Settings
> System Settings
.
Audio muted.
Press the
!
button on TV or receiver
remote control.
TV power off.
Switch TV on.
No picture
The receiver can't receive the
signal.
Check the antenna cable, replace the
cable, or connect the cable to the
receiver tightly.
Incorrect values of some tuner
parameters (e.g. one/some
channel(s) changed to another
TP).
Set the values of tuner parameters
correctly in menu
Installation >
Channel Search
. Helpful websites are:
http://de.kingofsat.net/
http://www.lyngsat.com/
Wrong direction of the antenna. Check the signal with a spectrum
analyser and adjust your antenna
correctly or consult a specialist.
