Fig. 6
Your dish should be aimed at the Astra satellite at 19.2 East. Ask your dealer to point your
dish on this satellite. Connect a coaxial cable between your LNB converter and the SAT
Input connector of your terminal.
If you connect your terminal to an existing local distribution network, check to which DiSEqC
input the Astra 19.2 E satellite is connected. If you connect the terminal to your existing
reception signal, check which DiSEqC connector your ASTRA 19.2 input is connected to.
P5
CONNECTIONS
3.4 Connect and use an IR extension
Fig. 6
Accessory not included, available to order at [email protected].
An IR extender allows you to place the terminal out of sight (in a cabinet) while still being able
to control it. Connect the IR extender connector to the back of the terminal. Place the IR sensor
so that it can receive the signal from the remote control. Once the location of the IR sensor has
been chosen. Remove the protective film from the adhesive on the back of the sensor, and
stick it by pressing it lightly on the surface where you want to place it.
4.0 FIRST START-UP
Check that the terminal is correctly connected to the television and the satellite dish and that
the signal is of good quality. If in doubt, consult your local dealer, who will check your
installation and the satellite signal. Check that the terminal plug is securely plugged into the
wall outlet. Insert the TNTSAT chip card upwards (gold contact upwards).
Switch on the terminal. The installation wizard appears on the screen if this is the first start.
We advise you to follow the steps step by step. This will make it easier for you to configure
the system and install the channels.
4.1 Language selection
Select the OSD language using the
▲ ▼
buttons and press OK to choose your preferred
language.
4.2 Preferences
In this menu you can set HD output resolution, SCART standard, aspect ratio, SPDIF standard,
HDMI standard, audio language and subtitle language. Please consult the manuals of the other
equipment connected to the terminal in order to select the corresponding settings Select your
preferences using thekeys
◄ ►
and press OK to confirm and continue the installation.
4.3 Parental control
This menu allows you to set yourpreferences
parental control
.
Verrouillagemenu
If activated, the PIN code will be asked to enter the main menu.
Maturity
level
Select the age group corresponding to the programs that you do not wish to make
accessible to children of the same age or of a lower age.
4.4 PIN code setting
You have to set the PIN code and confirm it. Using the number keys enter the desired code
and confirm it. You must memorize this PIN code, you will be asked to access certain menus
and certain programs for which the level of morality exceeds that preset in the terminal. The
PIN code “0000” is not valid.
4.5 Antenna adjustment
Your dish should be pointed on the Astra satellite at 19.2 ° East. If a DiSEqC switch is fitted
between the frequency converter and the terminal, select the corresponding input. If necessary,
gradually adjust the position of the dish until the bars indicating the signal strength and quality
