STaRTInG UP FoR THe FIRST TIme
P7
En
g
lis
h
3.2 connecting the TV set
Fig. 10
Connect one end of a good quality HDMI cable to the HDMI connector of your receiver and the other
end to the HDMI input of your TV set. Plug the power adapter jack to the receiver and the other end to a
suitable wall outlet.
3.3 connecting to the world wide web
Fig. 10
The receiver connects to the Internet through the Internet router or DSL/cable modem in your home
network. The receiver can connect to the home network over its Ethernet port - through direct connection
to the router, over PLC (Power Line Communication) adapters or compatible USB WLAN adapters.
3.3.1 connecting via the ethernet port
Fig. 10
Connect one end of the Ethernet cable to the receiver and the other end to the LAN port at the router or
DSL/cable modem.
3.3.2 connecting via a compatible USb wlan adapter
Fig. 10
Connect the USB adapter to one of the USB ports on the back panel of the receiver. On the Network menu,
set the options for the WLAN as follows:
Network name (SSID)
:
Select the network name of your WLAN access point from the list.
Security Type (WEP, WPA, WPA2):
The receiver supports WEP 40/128bit ASclI, WEP 40/128bit HEX, WPA and WPA2.
The settings of the security type of the WLAN and the receiver shall be the same.
Password
:
When using the security type, you must set the password. Enter the same
password in the WLAN setting menu.
noTe:
To improve quality of service, keep the distance between the WLAN access point and the
receiver close.
3.4 connection to a DVD or VcR recorder
Fig. 10
The DVD or video recorder may be connected to the receiver via the video and analogue stereo audio
outputs.
noTe:
The A/V output of the DVD recorder or VCR recorder needs to be connected to the TV directly
and cannot be connected to the receiver.
3.5 connection to main power supply
Fig. 10
After all the connections are done you can connect your receiver to power using the supplied external
AC/DC adapter. Now plug the adapter into the wall socket. Then set the power switch on the rear panel in
position 1
(on)
.
4.0 STaRTInG UP FoR THe FIRST TIme
The first time you turn on the receiver, a
Quick Start Guide
menu will be open to assist you with the initial
settings. This menu will also appear after you do a Factory Reset. Use the
GReen
and
ReD
buttons on
the remote control to navigate forward or back through the wizard steps. Press the
ok
button to edit a
parameter and select its value from the drop list that will appear on the right side of the screen.