THOMSON THBI6814WD, Operating Instructions Manual

Page: 36 / 83

6
INSTALLATION
Unpacking
All transit bolts at the rear of the appliance and packing must be
removed before using the appliance.
Keep all packaging away from children.
Keep all the transit bolts for re-use in case the appliance is to be
transported again.
Positioning
Install the appliance on a flat hard floor.
Make sure that there is sufficient space for air circulation around the appliance.
Do not install the appliance on a carpeted floor.
Water inlet
Screw one end of the inlet hose on the back of the appliance.
The appliance must be connected to a cold water supply.
Connect the other end of the inlet hose to a tap with a 3/4 ”
thread.
Electrical connection
Your washing machine works with 220-240V and 50Hz.
Electrical connections must be carried out by a qualified technician in compliance
with the current safety regulations.
Your washing machine must be properly earthed. We will not be held responsible for
any damage that may occur as a result of usage without correct earth connection.
Do not use extension leads or multi-sockets.
Water drainage
To install the drain hose, please use one of the following
methods.
1. Push the hose firmly into a drainage standpipe.
OR
2. Connect the drain hose onto a sink outlet spigot
securely.
Notes:
Make sure that the water drain hose does not bend,
buckle, is not crushed or extended.
The water drain hose should be mounted at a height of minimum 60 cm, maximum
Downloaded from www.vandenborre.be