THOMSON SPEEDTOUCH 546 - VERSION 6, Installation And Setup Manual

Page: 12 / 42

Chapter 2
Basic Installation
6
E-DOC-CTC-20051017-0068 v1.0
2.1 Setting up your SpeedTouch™
Setup possibilities
You can mount the SpeedTouch™ on a wall, set it up upright or simply place it on a
desk.
Wall mount
Proceed as follows to mount the SpeedTouch™ on a wall or other vertical surface:
1
Drill two holes in the wall or other vertical surface where you want to place the
SpeedTouch™.
2
Fasten two screws in the wall holes. The screws should protrude five
millimetres from the surface of the wall.
3
Attach your SpeedTouch™ on the wall using the two mounting slots on the
bottom.
Stand-up
To set up the SpeedTouch™ in an upright position, use the cradle (if available).
If you install the SpeedTouch™ onto plasterboard, use dowels to
secure the screws. Otherwise the strain of the cables connected to the
SpeedTouch™ rear panel connectors could pull the SpeedTouch™
from the wall.