Programming the ROC 850
10
Programming using the auto scan method
If you were unable to find the satisfactory code using the manual entry or make scanning
methods, try the auto scan method below.
Note: this method presumes you wish to memorize a VCR code under the VCR mode, a satellite receiver
code under the CBL mode, etc …To memorize, for example, a VCR code under the CBL or other code, the
CBL mode key must be dedicated to the list of VCR codes.You can assign any VCR code under the CBL
mode, by applying the method described in page 8, before scanning.
1.
Switch on the device to control (TV,VCR, …).
2.
Activate the touch screen by pressing it.
3.
Press and hold the
SETUP
(
6
) key until the red indicator remains lit (2-3 seconds) and the
following screen displays (Setting screen). Release the
SETUP
key.
4.
Press the
CODE
key on the touch screen.The following screen displays (MODE screen).
5.
Press a mode key (
TV
,
VCR
,
SAT
...) on the keypad (
2
) according to the device to control.
The next screen appears (CODE screen).
6.
Press the
SEARCH
key on the touch screen once.The SEARCH screen
displays.
7.
Press the
key on the touch screen (or the
B
or
PLAY
keys in the keypad).The remote
control returns a series of codes and beeps.When the device turns off or changes channel
press the
(
7
) key immediately to memorize the corresponding code.The main screen
redisplays. Code scanning is complete.
Note: point the remote control towards the device and press the
B
key (
3
) on the keypad. If the device
switches on, this means the code found by the remote control is correct.You only need to check that the
various keys on the touch screen proposed on the screen enable controlling the device concerned. If touch
keys are inoperative, reprogram by make scanning, by restarting the procedure.
8.
Repeat this procedure for the other devices to control (
TV
,
VCR
,
DVD
,
SAT
,
AUX
).
Note:
• once all the codes matching a make have been tested, the red indicator blinks 3 times to indicate that
scanning is complete, and the main screen displays.
• Code scanning starts from the last code memorized under the mode concerned. Therefore, if auto scan
tests the 100 mode codes concerned, and if the code in memory in the remote control is code 050, code
search will start from code 051 up to code 100, then returns to 000 to 050.
ROC850_en 26/09/03 16:06 Page 10
