MEC 2 MICROPROCESSOR ENGINE/GENERATOR CONTROLLER
PM056 Rev 6 05/10/15
Thomson Technology
14
held down, the displayed value will be “decremented” to a lower value as desired.
Note:
The longer the pushbutton is held down, the faster the value will be
decremented.
INCREMENT
pushbutton. The
INCREMENT
function is used to change a
programming value while in the programming mode or to select a desired
programming menu loop. When this pushbutton is held down, the displayed
value will be “incremented” to a higher value as desired.
Note:
The longer the
pushbutton is held down, the faster the value will be incremented.
ENTER
pushbutton. The
ENTER
function is used to scroll forwards
through the status menus or programming prompts to the next item. The
ENTER
function is used to “enter” a programming mode as well as accepting changed
programming values.
Note:
In the programming mode, the longer the
ENTER
pushbutton is held down, the faster the next menu prompts will appear.
RUN pushbutton and LED light viewing window. The RUN function is
used to initiate a manual start signal to the engine-generator set. Refer to the
operating instructions for detailed information.
OFF pushbutton and LED light viewing window. The OFF function is
used to initiate a stop signal to the engine-generator set. Refer to the operating
instructions for detailed information.
AUTO pushbutton and LED light viewing window. The AUTO function is
used to initiate automatic operation of the engine-generator set. Refer to the
operating instructions for detailed information.
LOAD TEST pushbutton and LED light viewing window. The LOAD TEST
function is used to initiate load test of the engine-generator set when connected
to an associated transfer switch. Refer to the operating instructions for detailed
information.
V
EMERGENCY STOP pushbutton and LED light viewing window. The
EMERGENCY STOP function is used to initiate an emergency stop signal to the
engine-generator set. Refer to the operating instructions for detailed information.
11
READY LED light viewing window. The READY LED illuminates when the
engine-generator set is set for automatic operation and no shutdown or alarm
faults have been activated.
12
SPEED SIGNAL LED light viewing window. The SPEED SIGNAL LED
illuminates when the engines speed signal is detected (i.e. the engine is turning
over).
13
ALARM LED light viewing window. The ALARM LED illuminates (flashes)
Summary of Contents for MEC 2
Page 2: ......
