Connections and initial set up
10
DMR
Satellite receiver
TV set
Satellite or cable receiver
IR controller cell
G-LINK CABLE - Adjusting your DMR’s IR (infrared) controller cell
You need to find the correct positioning of the IR controller cell in relation to the front of the
satellite or cable receiver so that your DMR can transmit the commands as you would do with
the satellite receiver’s remote control.The IR (infrared) controller cell must face the receiver cell
of the satellite receiver.You can locate the receiver cell of the satellite receiver by bringing its
remote control as close as possible to the front of the device and trying to change channels.
Move the remote control one centimetre and try again.When the channel of the satellite receiver
changes, locate the position on the front of the unit.Then install the IR controller cell as shown
on the diagram below, facing the cell of the satellite receiver (1 or 2 cm away). If need be, use the
adhesive supplied to stick the cell in place.
Satellite or cable receiver
Your DMR is intended to control a satellite or cable receiver. In this case, the device must be
connected to the AV2 and IR SAT/CABL connections of the DMR. Connect cables (5) (not
supplied) and cable (6) the G-LINK cable (supplied) as shown below.
Note: In grey: connections already carried out (connections from page 4),
In black: new connections.
5
6
DTH7500_en 4/07/03 16:55 Page 10
