Page 9 of 18
5. Cleaning and maintenance
CAUTION!
Risk of serious injury or death by means of electrical shock
Before any maintenance or cleaning jobs are performed always assure the rocker switch is
switched to “O” and the power plug is removed from the power circuit
5.1 Daily cleaning
Clean the cutlery polishing machine daily by following these Steps:
1.
Assure the rocker switch is switched to “O” and the power plug is removed from the power circuit.
2. Open the top cover to the machine and remove the granulate dust from the polishing bin, cover sheet,
frame and top cover with a damp cloth.
3. Remove the granulate dust from the UVC lamp with a dry cloth. The UVC lamp is found underneath the
front cover. (See picture 1 or picture 2 on page 10)
WARNING!
Damage may occur to the frame and / or the electronics
The in and outside of the machine should never be exposed to water.
Never hose down the machine or use a high pressure cleaner on it.
Never use cleaning powder, acid, leaching, steel wool or wire brushes to clean
the machine.
5.2 Replacing the granulate and cleaning the machine
The granulate must be replaced after approx. 200 operating hours or 8 weeks for hygienical
reasons.
Replace the granulate prior to if :
it is heavily filled with food leftovers.
it soaked up too much water and is wet.
It is heavily greasy (Granulate is dark).
1. Before changing the granulate, turn off the machine by switching the rocker switch
to „O“ and disconnect the power plug.
2. Open the top cover. Remove the cover sheet on the polishing bin by loosening
and removing the star grip. (See picture 1) Open the front cover by removing the
the 2 top screws (See picture 2 or page 10, Position 1-2).
3. Vacuum out the granulate with a vacuum cleaner (See picture 3). Clean the
Interior area if needed.
4. Spray cleaning alcohol on the polishing bin, cover sheet and top cover and wipe
Off with a dry cloth.
5. Remount cover sheet and front cover after cleaning.
6. Insert a complete filling of original Dörr polishing granulate Type SG 3000L into
The polishing bin.
7. Close the top cover. The Machine is now ready for use.
Picture 1
Picture 2
Picture 3
UVC-
Lampe
Summary of Contents for TD 3000L M14
Page 18: ...Page 18 of 18...
