TA01116 B
Page 1 of 2
INSTALLATION
1. To remove top, loosen (4) screws and
rotate top plate away from screws.See
Figure 1
.
2. Install conduit connectors as needed.
3. Replace top and tighten (4) screws.
4. Adjust box so that top edge is 1/16”
below screed line using (4) leveling
screws furnished. Attach conduit and
secure box to form. See
Figure 2
.
INSTALLATION INSTRUCTIONS
FOR CONCEALED SERVICE FLOOR BOX
Catalog Number: 665-SC
IMPORTANT:
Read all instructions before installing floor box, carpet plate or mounting kit.
Figure 2
LEVELING SCREW
WARNING
ELECTRICAL HAZARD!
BE SURE POWER IS OFF!
CAUTION
FLOOR BOX SHOULD BE INSTALLED BY
A QUALIFIED ELECTRICIAN IN
ACCORDANCE WITH NATIONAL AND
LOCAL ELECTRICALCODES.
Figure 1
LOOSEN SCREWS,
ROTATE PLATE
665-CST
(NOT INCLUDED)
DEVICE PANEL
(NOT INCLUDED)
NON-METALLIC
TUNNEL
665
FLOOR
BOX
MINIMUM CONCRETE DEPTH FOR THE 665-SC
FLOOR BOX IS: 3-1/2” DEEP
