Title
Vectro2 for Universal Robots Quick start guide
Document #
D21-2027
Issued date
14 Sep 2021
Revision
1.0
Issued by
R. Clarke
Confidential
Page 9/12
Before using the Vectro2 in a program you will need to connect to it and setup data output
locations.
Enter into the Vectro installation by
navigating through: Installation ->
URCaps -> Vectro.
This should show the Vectro installation
screen, similar to the one shown.
This is where you connect to the
Vectro2, clicking the dropdown will
present a list of Vectro and GapGun
devices found on the local network.
If the device needed is not shown click
the box and you can enter a hostname or
IPv4 address.
Click ‘Device enabled’
A green tick means the connection was
successful.
While a red cross & timeout means you
need double check IP address and plug in
connections, also the network
connection if it persists.
Note: If the page says unlicenced you will
need to update the license on the
Vectro2 (as covered in the Vectro2
manual).
